〣Product introduction

Printing plate, also known as printing color steel plate. It refers to the process of printing various patterns on steel plates by technical means on the basis of various substrates.

〣Matters needing attention

1. If punching and trimming are needed in the use of printing board, the exposed section formed by it needs to take supplementary drawing anti-rust measures to prevent corrosion.

2, the use of rolling equipment for processing should avoid sharp instrument collision, excessive stamping, extension, etc.

3, inside the opening, handling should avoid impact, folding, mutual friction to avoid damage to the surface pattern.

〣Specification requirements

Under normal circumstances, printing board can be selected according to the standard color of the manufacturer, which can shorten the workload in the early stage of production. If you need special color, because the paint first in the paint production factory sample configuration, and the performance to meet the requirements of production, so from the order to the printing plate production time will be longer. The higher the value, the higher the glossiness of the coating surface measured by the 60 degree reflection Angle. The light and matte in the coatings used on buildings are between 30 and 55. This is because of the high gloss paint used in buildings on the sun reflection strong, dazzling; If indoors, at night under the light is easy to cause visual fatigue.

Printing board coating is baked synthetic resin coating, in outdoor use, due to the influence of sunlight, temperature and rain, the film will gradually deteriorate, small observation steel surface, or fingers gently touch, you can find the existence of white powder. This phenomenon is the coating powder, which is inevitable. But choose different types of coating, can delay the occurrence of pulverization years. In addition, the service life varies in different areas such as coastal areas, industrial areas and rural areas. Once the coating powder and cracking corrosion, should be repainted to extend the service life.

Printing board is a new type of building materials, for construction, vehicle manufacturing, furniture, electrical and construction industries have brought a lot of convenience, not only can play the effect of steel instead of wood, but also has the advantages of saving energy, improving construction efficiency, avoid environmental pollution and so on.

When pressing the defects of the paint, the paint resin material caused by the primer and passivation layer is not good contact. Until both ends of the plate are fixed. A simple and effective method is to use a pair of clamp pliers to clamp the local lap steel plate respectively. Dust will affect the surface quality of the finished color coated board, especially may produce color coated board aging blasting paint quality defects, granular dust may also scratch the paint of the color coated board.

Different types of color coating plate should be placed on the rubber pad, pad wood, bracket and other devices, binding buckle should be upward, can not be directly placed on the ground or transport vehicles.

The quality of the printing board is important, but the appearance of the surface can not be ignored, so we must avoid the possibility of scratching the finish paint during production.

〣Paramenters